Craftsman 113.298761 - Manual (Page 8)

unpacking and checking contents
TOOLS NEEDED
Wrenches
7/16 In. 1/2 In. 3/16 In.
Phillips Screwdriver
Medium Screwdriver
Small Screwdriver
Set Screw Wrenches
3/32 In,
1/8 In.
5/32 In.
COMBINATION SQUARE MUST 8E TRUE.
STRAIGHT EDGE OF BOARD
3/4" THICK. THIS EDGE MUST
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION.
Separate all parts from packing materials and check
each one with the illustration and the list of Loose Parts
to make certain all items are accounted for, before
discarding any packing material.
WARMING: If any parts are missing, do not attempt
to assemble the tablé saw, plug in the power cord or
turn the switch on until the missing parts are ob­
tained and are Installed correctly.
Remove the protective oil that is applied to the table top
and edges of the table. Use anyordinary household type
grease and spot remover.
WARNING: Toavoid tire or health hazard, never use
gasoline, naptha, or similar highly volatile solvents.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth,
WARNING: Foryour own safety, never(»}nnect plug
to power source outlet until all assembly steps are
complete, and you have read and understand the
safety and operational Instructions.
ITEMI
A
B
c
D
E
H
M
Q
R
S
T
U
G
J
AM
PART NAME QTY.
Blade Guard and Spreader...............................1
Rip Fence...........................................................
1
Owner’s Manual......... ...... ................................ 1
Cast Iron Table Extensions........ .......................2
Miter Gauge ....................................................
1
Rip Fence Guide Bar with Rip Scale (Front). 1
Support, Motor Base........................................ 1
Rip Fence Guide Bar (Rear)........................... 1
Side Stiffener.,............... ....................................2
Leg....... .................... ......... ....... ....... ................. 4
End Stiffener................................................. .2
Motor.............................................................. ...1
Bag of Loose Parts
(Containing the following items)
Outlet, On/Off with Key.............. ......................1
Handwheel..................................................... 2
Bracket, "L" Mounting (Model 113.298721) .1
Bag of Loose Parts............................................3
Bag of Loose Parts
(Containing the following Hems)
Wrench............................................................ 1
Belt, “V" 1/2 X 41....................................... .....1
Pulley, 1/2 dia. with 5/8 Bore......................... 1
Spreader, Rod ...,......................................... 1
Blade Guard Support .................................... 1
Spreader Support......................................... ...i
- IL ///
(MODEL 113.298721)