Craftsman 113.298761 - Manual (Page 42)

adjustments
C. If blade is NOT SQUARE to table... the 90® Stop
Screw must be ADJUSTED.
1. Unscrew 90® Stop Screw three to four turns
using 3/16 inch Hex “L” wrench.
2. Turn Tilt Handwheel etockwise one turn, then
turn Handwheel counterclockwise until blade is
square with table.
3. Screw 90° Stop Screw IN until It stops. Check
once again for squareness and readjust screw,
if necessary.
45® i^ositiori
TILT blade to LEFT as far as It will go.
1. Place an ACCURATE square against blade. Make
sure square is not touching the TIP of one of the saw
TEETH.
If blade is 45° to table;
t. Check Pointer.
if blade is NOT 45° TO TABLE... STOP SCREW and
SCALE must be ADJUSTED.
1. Unscrew 45° Stop Screw three to four turns using
3/16 inch setscrew wrench.
2. Turn Tilt Handwheel until blade IS 45“ to the table.
3. Screw 45“ Stop Screw IN until it stops. Check once
again and readjust screw, if necessary.
If POINTER DOES NOT point to the 45° mark on the
scale;
1. Remove Elevation Handwheel.
2. Loosen two screws on Scale and adjust Scale until
Pointer points to 45“ mark.
3. Install Elevation Handwheel.
mt MECHANISM
The Handwheel should turn freely without binding. The
turning action can be adjusted by tightening or loosening
the screws in the Bearing Retainer,
NOTE:
nit
Handwheel must be removed to adjust.
When adjusting the screws in the Bearing Retainer, hold
the nut inside using a 3/8 inch wrench.
42