Assembly – Craftsman 113.298761 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

assembly

6. Slide the Bars so that screwsare in the MIDDLE of the

slotted holes.

7. Position Rip Fence overMiterGauge Groove, holding

up the rear end while engaging front end with Bar,
Lower Fence onto table.

8. Raise blade all the way up.

9. Carefully move Fence against blade.

10. Move Front Bar until "0" mark on Rip Scale is

approximately in line with tip of Pointer.

11. Move Front Bar upwards until Fence is approxl-

mately 1У32 inch above table. Tghten screw at left
end of Bar.

NOTE: Fold a piece of newspaper making 8 thick
nesses and place between Rip Fence and table to
act as a spacer. This will hold the Fence off of the
Ше approximately 1/32 inch.

12. Adjust Rear Bar so that the Fence is approximately

1/32 inch above table, make sure it is square with
Miter Gauge Groove. Tighten screw at end of Bar.

8 THICKNESSES

OF PAPER

e THICKNESSES

13. Move Fence to RIGHT edge ol table. Make sure it is

approximately 1/32 inch above table at front arxl
rear and tighten screws.

This manual is related to the following products:

113.298721