Craftsman 113.298761 - Manual (Page 40)

adjustments
3. Place the head of a combination square in the
GRCX)VE. Adjust blade of square so that it just
touches the tip of the MARKED tooth.
4. MovesquaretoREAR.rotatebladetoseeifMARKED
tooth again touches blade of square.
5. If tooth touches square at FRONT and REAR,
sawblade is PARALLEL to Miter Gauge Groove.
6. If tooth does not touch the same amount, the mecha­
nism underneath must be adjusted to make the blade
PARALLEL to GROOVE.
A. Rear Trunnion trust be moved TOWARD to com-
binalion square If there is a space between marked
tooth and end of square in step 4.
B. Rear Trunr^on must be moved AWAY front the
square if marked tooth pushes square out of posi­
tion in the groove.
. Loosen all three screw« that hold the Rear Trunnion
and all three screws that hold the Front Trunnion.
MOTE: All six screws can be reached through back
of saw. Use a 9/16 inch wrench. To reach left-hand
Front Trunnion screw, lilt blade to 45“. After loosen­
ing screws, reposition blade at 90“.......................
REAR-TRUNNION
SCREWS
8. Using awoodblock and mallet, as shown, move Rear
Trunnion to right or left as required to realign the
blade. If necessary, shift Front Trunnion in similar
manner; but do NOT move Front Tiunnion unless
necessary. Recheck the alignment with the square,
then securely retighten all six Trunnion screws.
40