Craftsman 113.298761 - Manual (Page 15)

6. Turn front bar end for end and insert bolts through
holes in middle and on right sides of front of saw table
as illustrated. Install lockwashers and nuts. DON'T
SCREW NUTS ON ALL THE WAY, just get them
started on the screws.
7. I nsert 1 -1 /4 long screw though slot in bar that matches
hole in bracket. Install spacer, lockwasher and nut.
DON'T SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
INSTALLING REAR FENCE GUIDE BAR
1. From among the loose parts find the following:
1 Bracket
*2 Hex Head Screws 5/16-18x1
*2 Hex Head Screws 5/16-18 x 3/4
*4 Flat Washers 5/8 X 1/16
*4 External Lockwashers 5/16
*4 Hex Nuts, 5/16-18
1 Rear Fence Guide Bar
Items marked with an asterik (*) are shown actual size.
9*11119mi
5/16-18 X 1 IN
HEX HD. SCREW
5/16-18x3/4
HEX HEAD
SCREW
FLAT WASHER
5/16 IN
EXTERNAL
LOCKWASHER
5/16-18
HEX NUT
REAR FENCE GUIDE BAR
2. Put the bracket against the right rear edge of the right
extension so the bracket is lined up with the FOURTH
hole near the rear of the extension (see illustration).
3. Insert one of the 3/4 inch long screws through a flat
washer, throughthe bracket, and through the FOURTH
hole in the extension. Install a lockwasher and nut on
the screw. Tighten the nut only slightly.
EXTERNAL
LOCKWASHER
REAR OF
EXTENSION
4TH HOLE
BRACKET
WASHER
5/16-18
X
3/4
HEX HEAD
SCREW
4. Lay rear fence guide bar on the right rear side of the
saw table as illustrated (as viewed from rear of the
saw). Insert a 3/4 inch long screw through a flat
washer and through the FIRST slot of the fear fence
guide bar. Insert a 1 inch long screw through a flat
washer and through the FIFTH slot. Insert a 1 inch
long screw through a fiat washer and through the
SEVENTHslOt.
5. Turn the fence guide bar end for end and inserttwo of
thel inch long screwsthroughihetwo holes ihthe ieft
rear edge of the table, insert the other 3/4 inch long
screw through the bracket. Install a lockwasher and
nut on bolts. DO NOT SCREW NUTS ON ALL THE
WAY, just get them started on the screws.
7TH SLOT 5TH SLOT 1ST SLOT
WASHER-^
HEX HEAD
SCREW
5/16-18 X1 IN
HEX HEAD
SCREW
5/16-18 X 3/4 IN.
BACK OF SAW
15