Craftsman 113.298761 - Manual (Page 43)

maintenance
WARNING: For your own safety, turn switch “OFF"
and remove plug from power source outlet before
maintaining or lubricating your saw.
Do not allow sawdust to accumulate inside the saw.
Frequently btow out any dust that may accumulate
inside the saw cabinet and the motor.
Frequently clean your cutting tools with Craftsman Gum
and Pitch Remover.
A coat of automobile-type wax applied to the table will
help to keep the surface clean and allow workpieces to
slide more freely.
If the power cord is worn or cut, or damaged in anyway,
have it replaced immediately.
Make sure the teeth of the Anti-Kickback Pawls are
always sharp. To sharpen:
1. Remove Blade Guard.
2. Rotate Pawl toward rear of Spreader so that teeth are
above top of Spreader.
3. Hold Spreader with left hand and place Pawl over
corner of workbench.
4. Using a small round file (smooth cut) sharpen the
teeth.
lubrication
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First clean with
Craftsman Gum and Pitch Remover.)
2. Elevation screw threads and pivot nut. (First clean
with Craftsman Gum and Pitch Remover.)
3. Cradle bearing points.
4. Bearing points in Guard Assembly, Miter Gauge and
sears recommends the following accessories
ITEM CAT. NO. ITEM CAT. NO,
Caster Sets.................................9-22222 or 9-22221
7 In. Molding Head Set .................................. See Catalog
7 In. Molding Head.................................. ....... See Catalog
8 In. Molding Head..................... .................. . See Catalog
Molding/Dado Insert for 7 In. Dia. Molding
or Dado Head.... .. .... ................ ........... ...9-29997
Molding/Dado Insert for 8 tn. Dia. Molding
or Dado Head.......... .......... ............................... 9-22287
Work Light..................................... .......... . See Catalog
7 In. Dia. Adjustable Dado Head.................... . See Catalog
7 In. Dia. Dado Head........................................ See Catalog
Sanding WheeI. .................. ............. ...... . See Catalog
Miter Gauge Stop Rods....................... ......... 9-29924
Miter Gauge Hold-Down Clamp.... ............ .9-29928
Taper Jig......... ................................... See Catalog
Universal Jig............... ........................See Catalog
Power Tool Know How Handbook................. ........ 9-29117
Sears may recommend other accessories not listed
in manual.
See your nearest Sears Store or Catalog Department
for other accessories.
Do not use any accessory unless you have received
and read complete Instructions for its use.
43