Assembly, Installing belt guard – Craftsman 113.298761 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING BELT GUARD
Model 113.298721 & 113.238761
1. Install three Clips (furnished with Guard) 90° apart
starting with one Clip at the end of the Guard as
shown. LONG END of Clip facing AWAY from you.
assembly
OPENING
BELT GUARD
CLIPS
2. Reinstall Motor Pulley the same way it was when you
aligned the Belt.
3. Place Belt on Saw Pulley. Insert end of Belt through
opening in END of Guard.
4. Slip Belt over Motor Pulley.
5. Press Guard onto Support so that bottom of Guard is
approximately 3/4 inch away from Belt.
NOTE: To remove Guarcl, lift up on LONG TABS of
Clips, pull Guard outward. The Clips Should remain
on the Belt guard Support.