Craftsman 113.298761 - Manual (Page 25)

getting to know your saw
8 TABLE tNSERT
10 EXACT-I-CUT
9 SAWBLADE
7 BLADE GUARD
ANTIKICKBACK
PAWLS
6 MITER GAUGE
HOLES FOR
ATTACHING FACING
4 TILT LOCK HANDLE
(UNDERNEATH TABLE)
2 ELEVATION HANDWHEEL
I ON-OFF SWITCH
ON-OFF SWITCH
CAUTION: Before turning switch "ON", make
sure the blade guard is correctly installed and
operating properly.
The On-Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO PREVENT UN­
AUTHORIZED AND POSSIBLEHAZARDOUSUSE
BY CHILDREN AND OTHERS.
A. To turn saw ON, stand to either side of the blade,
never in line with It, insert finger under switch
lever and pull END of lever out.
After turning switch ON, always allow the blade to
come up to full speed before cutting.
Do not cycle the Motor Switch on and off rapidly,
as this may cause the sawblade to bosen. In the
event this should ever occur, albw the sawblade
to come to a complete stop and retighten the
arbor nut normally, not excessively. Never leave
the saw while the power in “ON".
B. TotumsawOFF, PUSH leverin. Never leave the
saw until the cutting tool has come to a complete
stop.
C. To lock switch in OFF position, hold switch IN with
one hand, REMOVE key with other hand.
WARNING: Foryourown safety, lower blade or
other cutting fool below table surface, (if blade
Is tiRed, return tt to vertical, 9(P, posRIon). Always
iock theswKch"OFP’. When sawisriot in tise,
remove key and keep it in a safe place. Also; in
the event of a power failure (all of your lights go
out) turn swHch off, lock it and removelhe key.
This will prevent the saw from starting up again
when the power comes back on.
25
3 TILT HANDWHEEL
KEY
(YELLOW PLASTIC)