Craftsman 113.298761 - Manual (Page 11)

ASSEMBLING STEEL LEGS
1. From among the loose parts, find the following hard­
ware:
*24 Truss Head Screws, 1/4-20 x 1/2" long
*24 Lockwasher, 1/4 External
•24 Hex Nuts. 1/4-20
*8 Hex Nuts, 3/8-16
*4 Leveling Feet
Items marked with an asterik (*) are shown actual size.
1/4 IN EXTERNAL
LOCKWASHER
1/4-20 X 1/2 IN.
TRUSS HEAD SCREW
1/4-20
HEX NUT
3/8-16
HEX NUT LEVELING FOOT
2. Assemble the legs as shown.
I nsert the Taiss Head Screws through the holes in the
legs, then through the holes in the Stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES
IN THE SIDE STIFFENERS MARKED “X”.
3. Install the lockwasher, screw on the nuts but do not
tighten until completely assembled.
4. Install Leveling Feet.
MOUNTING SAW
1. From among the loose parts, find the following hard­
ware.
*4 Hex Head Saews, 5/16-18 X 1-1/4” long
*4 Hex Nuts, 5/16-18
*4 Lodiwasher, 5/16 External Type
*8 Flat Washers, 11/32 x 11/16 x 1/16
Items marked with an asterik {*) are shown actual size.
EbMHI C/
V-1 CMC ^ M ÌM
5/16-18x1-1/4 IN
HEXHEAD SCREW 5/16-18
HEX NUT
5/16 IN EXTERNAL WASHER
LOCKWASHER
11