Dadoing, Back of saw, Molding cuittnig – Craftsman 113.298761 User Manual
Page 38: Using featherboards for nonthru sawing, Dadoing molding cutting, Basic saw operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DADOING
tnstrucllons for operating the Dacio Head are contained
in booklet furnished with the Dado Head.
The arbor on the saw, is only tong enough so that the
widest cot that can be made Is 13/16 inch wide.
It is not necessary to instail the outside loose collar
before screwing on the arbor nut. Make sure the arbor
nut is tight.
ALWAYS USE DADO INSERT LISTED UNDER ^REC
OMMENDED ACCESSORIES."
V\rtien using the Dado Head it will be necessary to
remove the Blade Guard and Spreader. USE CAU
TION.
USE
MITER
GAUGE,
FENCE,
FEATHER-
BOARDS OR PUSH STICKS, etc. AS REQUIRED.
ALWAYS
REPLACE
THE
BLADE,
GUARD
AND
SPREADER WHEN YOU ARE FINISHED DADOING,
basic saw operation
i
LOOSE COLLAR
ARBOR NUT
SAW ARBOR
REMOVE SAWBLADE AND I
INSTALL DADO HEAD
BACK OF SAW
MOLDING CUITtNIG
Instnjctions for operating the Molding Head are con
tained in a booklet furnished with the Molding Head.
Always use Molding Insert listed under “RECOM
MENDED ACCESSORIES".
When using the Molding Head, It will be necessary to
removethe Blade Guard and Spreader. USE CAUTION.
USE MITER GAUGE, FENCE, FEATHERBOARDS OR
PUSH STICKS, ETC. AS REQUIRED.
ALWAYS
REPLACE
THE
BLADE
GUARD
AND
SPREADER WHEN YOU ARE FINISHED MOLDING.
USING FEATHERBOARDS FOR NON
THRU SAWING
Featherboards are not employed during nott thru-saw
ing operations when using the Miter Gauge.
Use
Featherbaords
for
all
other
non
thru-sawing
operations {when sawbfade guard must be removed).
Featherboards are used to keep the work in contact with
the ferae and table as shown arKf to stop kickbacks.
Add 7-1/2 inch h^hf lat facing board to the fence, the full
length of the fence. Mount Featherboard to fence and
tatrie as shown, so that leading edges of Featherbaords
will support woriqjiece until cut is confíete, and the
workpiece has been pushed conpletely past the cutter
(sawblade, dado head, molding head, etc.) with a Push
Stick, as in ripping.
Before starting the operation (switch "OFF" and cutter
below table surface):
1. Install Featherboards so they exert pressure on the
workpiece; be positive they are secure, and
2. Make sure by trial that the Featherboards will stop a
kickback it one should occur.
Replace the sawblade guard as soon as the non thru-
sawing operation is complete.
38