Craftsman 113.298761 - Manual (Page 22)

5. From among the loose parts, find the following
hardware:
*4 Carriage Bolts, 6/16-18 x 3/4
*4 Hex Nuts 5/16-18
*4 Lockwashers, 5/16 External Type
1 Motor Pulley
1 Beit Guard “L" Bracket
1 Belt Guard Support Bracket
Items marited with an asterisk (*) are shown actual size.
assembly
(Тши
MOTOR
PULLEY
BELT GUARD
SUPPORT BRACKET
5/16-18 X 3/4 IN 6/16-18 5/16 IN EXTERNAL
CARRIAGE BOLT HEX NUT LOCKWASHER
POSITIONING MOTOR ON MOTOR MOUNTING
BASE
Model 113.298761
1. Put the motor mounting base against the flat surface
of a workbench.
2. Position the motor so the end with terminal cover is
facing you.
3 . Loosen both cradle clamp screws.
4 Put a square against the LEFT side of the motor and
against the top of the workbench.
5. Turn the motor inside the cradle clamps until the top
Of both capacitors touch the square.
6. Tighten froth cradle clamp screws to hold the motor in
this position.
WARNING; Failure to properly install motor may let
workpiece strike capacitor cover during bevel or
compound mKer cuts.
LOOSEN BOTH CRADLE CLAMP SCREWS
CAPACITORS
SQUARE
MOTOR
MOTOR MOUNTING
BASE
WORKBENCH
z.. '
MOUNTING MOTOR ON MOTOR BASE
Modem3.298721&113.29876i
1. Place Motor on Motor Base so that shaft is pointing
to the right. Insert bolts through holes in Base, then
through the Motor Mounting Báse. Install lockwashers
and nuts, DO NOT TIGHTEN AT THIS TIME.
2. Positfon Motor so that edge of Motor Foot and Motor
Base are even. Slide Motor all the vyay to the RIGHT.
Slip the long part of the "L" Bracket fully under №ie
Motor so the short part is just under shaft (Model
113.2S8721 only). Tighten the four nuts.
3. Loosen set screw in Motor Pulley using 5/32 inch
setscrew wrench. Slide Pulley on shaft with HUB
away from Motor. DO NOT TIGHTEN SETSCREW.
4. Install 3/16 inch square key (furnished with Motor) in
grooves in Pulley and Motorshaft. DONOTTIGHTEN
SETSCREW.
WELDED MOTOR
MOUNTING BASE
INSTALLING BELT
Model 113.298721 & 113.298761
1. Lift Motor and insert the TWO PINS on Motor Base
into HOLES in Cradle. Push Motor in as far as it will
go.
2. Lbwerfhe blade, install Belton Saw Pulley and Motor
Pulley.
3. Sight along edges of both pulleys and move Motor
Pulley so that belt is parallel to the edges of both
Pulleys. Tighten the set screw in the Motor Pulley.
22