Aligning rip fence, Self aligning spring adjustment, Aligning rip fence self aligning spring adjustment – Craftsman 113.298761 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ALIGNING RIP FENCE
The Fence should slide easily along the Bars and always
remain in alignment (parallel to sawblade and Miter
Gauge Grooves).
The alignment is maintained by a spring underneath the
Fence which bears against the Front Guide Bar.
To move the Fence, loosen the Lock Handle and grasp
the Fence with one hand at the Iront.
SELF ALIGNING SPRING ADJUSTMENT
Place Fence on saw but DO NOT LOCK IT.
Move the REAR END of the Fence slightly to the right or
left. When you release It, the Fence should “spring" bade
to its original posftion.
If itdoes not, thé spring pressure must be INCREASED.
1. Loosen the screws,
2. Move spring slightly toward front of Fence. Tighten
screws.
17