Craftsman 113.298761 - Manual (Page 20)

asseinbly
6 Insert Spreader Rod into Spreader Support until pin
fits into notch. Insert Thumbscrew and tighten it.
7.
8 .
9.
Slide Spreader Rod into Blade Guard Support until
end of Rod is even with edge of SupfKort. Tighten
Hex Head Screw in Support.
Attach Spreader to Spreader Support so that the
edge of the Spreader is even wrth the edge of the
Spreader Support. Tighten screws.
Raise Anti-Kickback Pawls (hold in place with a set-
screwwrench -see below). AlignSpreaderSQUARE
to table.
Tighten both 5/16-18 X1 inch Hex Head Screws. 1/4-20 HEX
HD. SCREW
1/4 IN. LOCKWASHER
1/4-20 HEX NUT
SI>READER EDGE
EVEN WITH SPREADER
SUPPORT EDGE
END OF ROD
EVEN WITH EDGE
OF SUPPORT
S/16-18 X 1 IN.
HEX HO. SCREWS
10. Raise blade alt the way up, make sure it is square
with table.
11. Raise Blade Guard. Lift up both Anti-Kickback
Pawls. Insert one of the Setscrew Wrenches in the
mtches to hold the Pawls out of the way.
12. Lay blade of square or other straightedge alongside
of blade. .......
13. Loosen Hex Head Screw in Guard Support and
move Spreader so that it touches blade of square.
Tighten screw.
14. NOTE; The Spreader is now square with the table
and af^foximately in line with the sawblade. The
Spreader requires kirther adjustment to aiign it PAR­
ALLEL to the blade and in the MIDDLE of the cut
(KERF) made by the sawblade.