Dell PowerEdge 2850 - Manual (Page 13)

Table 2-2. Front-Panel LED Indicators, Buttons, and Connectors
SCSI Hard-Drive Indicator Codes
If RAID is activated, two indicators on each of the hard-drive carriers provide information on the status of the SCSI hard drives. RAID can be enabled either by
using ROMB on the optional riser card or by using a RAID card connected to the backplane. See
Figure 2 -2 and Table 2 -3 . The SCSI backplane firmware controls
the drive power-on/fault indicator.
Figure 2-2. SCSI Hard-Drive Indicators
NOTE: Hard drives bays are numbered 0 through 5 starting at the lower leftmost drive bay.
Indicator, Button,
or Connector Icon Description
blue system status
indicator Does not operate when the optional bezel is removed. The LCD display indicates the status.
amber system
status indicator Does not operate when the optional bezel is removed. The LCD display indicates the status.
LCD display Provides system ID, status information, and system error messages.
The LCD display lights up during normal system operation. Both the systems management software and the identification
buttons located on the front and back of the system can cause the LCD to flash blue to identify a particular system.
The LCD display flashes amber when the system needs attention due to a problem with power supplies, fans, system
temperature, or hard drives.
NOTE: If the system is connected to AC power and an error has been detected, the LCD display flashes amber regardless of
whether the system has been powered on.
power-on indicator,
power button The power-on indicator lights when the system power is on. The power-on indicator blinks when power is available to the
system, but the system is not powered on.
The power button controls the DC power supply output to the system.
NOTE: If you turn off the system using the power button and the system is running an ACPI-compliant operating system, the
system performs a graceful shutdown before the power is turned off. If the system is not running an ACPI-compliant
operating system, the power is turned off immediately after the power button is pressed.
system
identification button The identification buttons on the front and back panels can be used to locate a particular system within a rack. When one of
these buttons is pushed, the blue system status indicator on the front and back blinks until one of the buttons is pushed
again.
USB connectors Connects USB 2.0-compliant devices to the system.
NMI button Used to troubleshoot software and device driver errors when using certain operating systems. This button can be pressed
using the end of a paper clip.
Use this button only if directed to do so by qualified support personnel or by the operating system's documentation.
video connector Connects a monitor to the system.