Dell PowerEdge RAID Controller S110 User Manual

Page 8

Memory

512MB or greater.

Physical Disk

At least one SATA hard disk drive (HDD) or SATA solid state drive (SSD).

NOTE:

The PERC S110 controller supports cabled configurations of up to four SATA

HDD or four SATA SSD physical disks.

• SATA-II HDD physical disks can be used with a PERC S110 adapter.
• SATA-II SSD physical disks can be used with a PERC S110 adapter.

Operating Systems

• Microsoft Windows Server 2012 R2
• Microsoft Windows Server 2012
• Microsoft Windows Server 2008 R2 (64-bit), including Hyper-V

virtualization

• Microsoft Windows Server 2008 (64-bit), including Hyper-V virtualization
• Microsoft Windows Server 2008 (32-bit)

NOTE:

For the latest list of supported operating systems and driver installation

instructions, see the system documentation at dell.com/support/manuals. For

specific operating system service pack requirements, see the Get drivers and

downloads section of the system documetation page at dell.com/support.

Supported Devices

PERC S110 adapter supports Dell-supported SATA-based tape devices and

SATA optical disk devices.

NOTE:

The PERC S110 adapter supports system boot to a tape using an internal Dell

RD1000 tape device. Select Continue while in the BIOS Configuration Utility

() for RD1000 to remain first in the boot order. The RD1000 option goes to

the end of the boot order listing if ~~is selected and you would not~~

be able to boot to it.

A5_bk0.book Page 6 Thursday, May 29, 2014 11:37 AM