Accessing the perc bios configuration utility – Dell PowerEdge RAID Controller S110 User Manual

Page 26

Enables you to create or delete a global or dedicated hot spare(s).

Enables you to view detailed information about any connected physical

disk.

Enables you to view detailed information about any virtual disk.

Rescans the disks to detect new or removed physical disks or virtual disks.

Changes the selected controller options, such as booting and virtual disk

warnings.

Enables the system to continue booting after you use the PERC BIOS

Configuration Utility.

Accessing the PERC BIOS Configuration Utility

1 Boot the system and wait until the message Press to

Configure

appears.

2 Press .

You have a maximum of three seconds to press , or the

system’s boot process continues.

CAUTION:

If SATA Controller is not set to RAID Mode, data might be destroyed.

Make sure to backup all data before changing modes.

NOTE:

If the PERC BIOS Configuration Utility does not appear and your system uses

a PERC S110, press to access the Dell system BIOS. At the SATA Settings

field, make sure that SATA Controller is set to RAID Mode. If the settings

are correct and the PERC BIOS Configuration Utility still does not appear contact

Dell support at dell.com/support.

A5_bk0.book Page 24 Thursday, May 29, 2014 11:37 AM