Dell PowerEdge RAID Controller S110 - Manual (Page 22)

20 Installing the Drivers
2 Select Continue to Boot and press .
3 Proceed with "Installing the Controller Drivers During the Operating
System Installation" on page 21.
Change the Boot Priority List for Devices (If Applicable)
To change the order of the devices (CD-ROM, optical DVD, and so on),
perform the following:
NOTE: If the PERC BIOS Configuration utility is open, select Continue to
Boot
, then press . Press to reboot the system.
1 Boot the system. When the POST screen appears, press .
2 At the Dell PowerEdge System screen, use the arrow keys to scroll to Boot
Sequence
. Press .
3 Make sure that Hard drive C: is the first device listed.
4 To change the sequence of other devices:
– Use the <+> key to move devices up, or the <-> key to move
devices down.
– Use the space bar to enable or disable a device.
5 Press to exit.
6 Press again. Select Save Changes and Exit and press
.
7 Proceed with "Installing the Controller Drivers During the Operating
System Installation" on page 21
A5_bk0.book Page 20 Thursday, May 29, 2014 11:37 AM