Dell PowerEdge R715 - Manual (Page 69)

Using the System Setup Program and UEFI Boot Manager 69
System and Setup Password Features
NOTE: For a forgotten password, see "Disabling a Forgotten Password" on
page 181.
Your system is shipped without the system password feature enabled. Operate
the system only with system password protection.
CAUTION: The password features provide a basic level of security for the data on
your system.
CAUTION: Anyone can access the data stored on your system if the system is
running and unattended.
Using the System Password
When a system password is assigned, the system prompts for the password
during start up.
Assigning a System Password
Before assigning a system password, enter the System Setup program and
check the System Password option.
When a system password is assigned, System Password is Enabled. If
Password Status is Unlocked, you can change the system password. If Locked,
you cannot change the system password. Disabling the password jumper on
the system board sets System Password to Disabled, and you cannot change
or enter a new system password.
When a system password is not assigned and the password jumper on the
system board is in the enabled position, System Password is Not Enabled and
Password Status is Unlocked.
To assign a system password:
1 Verify that Password Status is Unlocked.
2 Highlight the System Password option and press .
3 Type your new system password.
You can use up to 32 characters in your password.
As you type, placeholders appear in the field.
book.book Page 69 Thursday, June 3, 2010 4:35 PM