Dell PowerEdge R715 - Manual (Page 118)

118 Installing System Components
5 Replace the cooling fan assembly. See "Installing the Cooling Fan
Assembly" on page 102.
6 Close the system. See "Closing the System" on page 79.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
iDRAC6 Enterprise Card (Optional)
Removing an iDRAC6 Enterprise Card
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 If applicable, disconnect the Ethernet cable from the iDRAC6 Enterprise
Card connector on the system back panel. See Figure 1-3.
3 Open the system. See "Opening the System" on page 78.
4 Remove the VFlash media card (if installed) from the iDRAC6 Enterprise
Card. See "Removing a VFlash Media Card" on page 121.
5 Pull back slightly on the two tabs at the front edge of the card and gently
lift the front edge of the card off the retention standoffs. See Figure 3-20.
As the card releases from the standoffs, the connector under the card
disengages from the system board connector.
6 Slide the card away from the back of the system until the RJ-45 connector
is clear of the back panel and then lift the card out of the system.
7 Close the system. See "Closing the System" on page 79.
8 Reconnect the system and peripherals to its electrical outlet, and turn
them on.
book.book Page 118 Thursday, June 3, 2010 4:35 PM