Dell PowerEdge R715 - Manual (Page 109)

Installing System Components 109
Removing Expansion-Card Riser 1
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 78.
3 If installed, remove the expansion card(s) from the expansion-card slot(s).
See "Removing an Expansion Card" on page 108.
4 If installed, remove the storage controller card. See "Removing the
Integrated Storage Controller Card" on page 113.
5 To remove the expansion-card riser, press the blue tab on the riser and lift
the expansion-card riser from the connector on the system board.
See Figure 3-16.
book.book Page 109 Thursday, June 3, 2010 4:35 PM