beautypg.com

Installing memory – Dell OptiPlex 740 User Manual

Page 91

background image

 

Installing Memory

 

 

1.

Follow the procedures in

Before You Begin

.


 

2.

If you are using:

l

 

a desktop computer: remove the optical drive (see

Removing an Optical Drive

).

l

 

a small form factor computer: first remove the optical drive (see

Removing an Optical Drive

) and then remove the floppy drive or media card

reader (see

Removing a Floppy Drive or Media Card Reader

).

 

3.

Press out the securing clip at each end of the memory module connector.

 

4.

Align the notch on the bottom of the module with the crossbar in the connector.

 

5.

Insert the module into the connector until the module snaps into position.

If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE:

To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your

computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

NOTE:

Memory purchased from Dell is covered under your computer warranty.

1 memory connector closest to processor

2 connector

3 securing clips (2)

1

cutouts (2)

2

memory module

3

notch

4

crossbar

 

 

 

 

NOTICE:

To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the

module.