Dell DX6004S - Manual (Page 94)

94 Installing System Components
CAUTION: Never operate your system with the cooling shroud removed. The
system may get overheated quickly, resulting in shutdown of the system and loss of
data.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 76.
3 Remove the SAS backplane cables routed over the shroud from the system
board.
4 Hold the touch points and gently lift the shroud straight up and away from
the system board. See Figure 3-10.
Figure 3-10. Removing and Installing the Cooling Shroud
1 power distribution board shroud 2 system board shroud
3 tabs (2) 4 fan bay numbers
1
2
3
4
book.book.book Page 94 Tuesday, September 7, 2010 8:45 PM