Dell DX6004S User Manual
Page 38
38
About Your System
Current boot mode
is set to UEFI.
Please ensure
compatible
bootable media is
available. Use
the system setup
program to change
the boot mode as
needed.
The system failed to boot
because UEFI boot mode is
enabled in BIOS and the
boot operating system is non-
UEFI.
Ensure that the boot mode is
set correctly and that the
proper bootable media is
available. See "Using the
Embedded NICx and
NICy:
OS NIC=
Management
Shared NIC=
The operating system NIC
interface is set in BIOS. The
Management Shared NIC
interface is set
in management tools.
Check the system
management software or the
System Setup program for
NIC settings. If a problem is
indicated, see
Error 8602 -
Auxiliary Device
Failure. Verify
that mouse and
keyboard are
securely
attached to
correct
connectors.
Mouse or keyboard cable is
loose or improperly
connected.
Reseat the mouse or
keyboard cable.
Defective mouse or keyboard. Ensure that the mouse or
keyboard is operational. See
Gate A20 failure. Faulty keyboard controller;
faulty system board.
Invalid
configuration
information -
please run SETUP
program.
An invalid system
configuration caused a
system halt.
Run the System Setup
program and review the
Table 1-2. System Messages
(continued)
Message
Causes
Corrective Actions
book.book.book Page 38 Tuesday, September 7, 2010 8:45 PM