Installing the power distribution board – Dell DX6004S User Manual
Page 132
132
Installing System Components
Installing the Power Distribution Board
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Unpack the new power distribution board assembly.
2 Align the power distribution board with the standoffs on the chassis.
3 Install the two screws that secure the power distribution board to the
chassis. See Figure 3-23.
4 Connect the power distribution cables to the system board (see "System
Board" on page 133) and fan cable connectors to the power distribution
board as shown in Figure 3-23.
5 Replace the power supplies. See "Installing a Redundant Power Supply" on
6 Replace the power distribution board shroud. See "Installing the Power
Distribution Board" on page 132.
7 Close the system. See "Closing the System" on page 77.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
book.book.book Page 132 Tuesday, September 7, 2010 8:45 PM