Dell DX6004S User Manual
Page 45
About Your System
45
Unable to launch
System Services
image. System
halted!
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
The optional iDRAC6
Enterprise card flash memory
or BMC SPI flash may be
corrupted.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server
Configuration user
documentation for
more information.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC 6 User Guide for
instructions on performing a
field replacement of the
flash memory.
Unexpected
interrupt in
protected mode.
Improperly seated memory
modules or faulty
keyboard/mouse
controller chip.
Reseat the memory modules.
See "Troubleshooting
page 145. If the problem
persists, see "Getting Help"
Unsupported CPU
combination.
Unsupported CPU
stepping
detected.
Processor is not supported by
the system.
Install a supported processor.
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x.
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
Table 1-2. System Messages
(continued)
Message
Causes
Corrective Actions
book.book.book Page 45 Tuesday, September 7, 2010 8:45 PM