Dell Inspiron 3800 - Manual (Page 56)

To remove the display assembly bezel, perform the following steps.
NOTICE: To avoid damaging the system board, remove the power cable, the battery, and the second
battery (if installed) before you service the computer.
1. Use a scribe to carefully pry the four rubber screw covers out of the four screw holes located at the top of the
bezel on the front of the display assembly.
2. Remove the four 4-mm screws located at the top of the bezel on the front of the display assembly (see Figure
14 ).
3. Use a scribe to carefully pry the two plastic screw covers out of the two screw holes located at the bottom of
the bezel on the front of the display assembly.
4. Remove the two 4-mm screws from the bottom of the bezel.
NOTICE: The bezel tabs are fragile. Handle the bezel carefully to avoid breaking the tabs off.
5. Separate the bezel from the display-assembly top cover.
The bezel is secured by three tabs on the left and right side of the display-assembly top cover.
1 Display assembly
bezel
6 Hinge cover
2 Latch 7 LCD panel
3 3-mm screws (6) 8 Plastic screw covers (2)
4 Display-assembly top
cover
9 4-mm screws (6)
5 LCD flex cable 10 Rubber screw covers (4)