Dell Inspiron 7000 - Manual (Page 77)

6. Remove PC Cards.
To remove PC Cards from the top connector, press the top eject button. When the button slides out, press it again to release the card. Gently remove the card. Press the eject button
again until it is flush with the computer casing. To remove PC Cards from the bottom connector, follow the same procedure.
Grasp the end of the card, and pull it completely from the slot.
7. Remove the hard-disk drive assembly.
Loosen the 2 captive screws that secure the hard-disk drive into the bottom of the computer. The front edge of the cover pops up slightly. Slide the hard-disk drive toward the front
of the computer and then lift the drive out of the computer.
8. Remove the memory module covers.
Slide the memory module cover as far as it will go in the direction of the arrow, and then remove the cover.
NOTICE: Use the PC Card configuration utility on the taskbar to select and stop a card before removing it from the computer. If you do
not remove the card in configuration utility, you could lose data from open application programs.
NOTICE: When the hard-disk drive is not in the computer, store it in a hard-disk drive case to protect it from exposure to static
electricity.
NOTICE: Handle the hard-disk drive gently and don’t bump or drop the drive. Rough handling of the drive could induce failure or loss of
data.