Dell Acceleration Appliances for Databases - Manual (Page 81)

4. Select OK and press Enter.
Changing the Gateway IP Address
1. Ensure that both nodes are up.
2. In the CLI, run
system:setup lan
to display the Setup dialog for LAN configuration.
3. Click the Routing tab in the dialog.
4. Change the gateway IP address.
5. Select OK and press Enter.
Changing the IP Addresses for Cluster Interconnect Ports
You can change interconnect ports only when no cluster resources are configured.
1. Ensure that both nodes are up.
2. In the CLI, run
system:setup lan
to display the Setup dialog for LAN configuration.
3. Change the cluster interconnect IP address in the dialog.
4. Select OK and press Enter.
5. Restart both nodes.
Changing the iSCSI Port IP Address
1. Ensure that both nodes are up.
2. In the CLI, run
system:setup lan
to display the Setup dialog for LAN configuration.
3. Change the iSCSI port IP address in the dialog.
4. Select OK and press Enter.
5. Add the new target session to the initiator by running the following command:
iscsiadm -m discovery -t st -p
address>
6. Log in to the target (all sessions) from the initiator:
iscsiadm -m node –l
7. Run the CLI command
initiators –dt
to display the new initiator.
8. Add this initiator to an existing initiator group:
initiator:update –a
75