Dell Acceleration Appliances for Databases - Manual (Page 80)

Appendix B: Changing Node Names and IP Addresses
______________________________________________________________________
This section explains how to change the names or IP addresses for ION Accelerator nodes once
they have been configured in the First Boot process. For details on using the
system:setup
command referred to in this section, refer to the ION Accelerator Appliance CLI Reference Guide.
Changing a Node Name in a Cluster
Changing a node name requires cluster downtime.
1. Ensure that both nodes are up.
2. Close all active sessions by disabling or disconnecting all target ports.
3. In the CLI, run
system:setup lan
to display the Setup dialog for LAN configuration.
4. Change the name of the node in the dialog.
5. Select OK and press Enter. Both nodes will restart, one at a time.
6. Repeat the previous two steps for the second node in the cluster.
Changing the Management IP Address
1. Ensure that both nodes are up.
2. In the CLI, run
system:setup lan
to display the Setup dialog for LAN configuration.
3. Change the management IP address in the dialog.
4. Select OK and press Enter. The node with the cluster IP address will fail over to the other
node.
Changing the ION Accelerator Cluster Name or Cluster IP Address
1. Ensure that both nodes are up.
2. In the CLI, run
system:setup cluster
to display the Setup dialog for cluster
configuration.
3. Change the cluster name in the dialog.
74