Compaq PROLIANT ML370 - Manual (Page 59)

Diagnostics and Troubleshooting 3-5
Utilities Access
The Compaq SmartStart and Support Software CD contains the SmartStart program and many
of the Compaq utilities needed to maintain the system, including:
■ System Configuration Utility
■ Array Configuration Utility
■ Array Diagnostic Utility
■ ROMPaq Firmware Upgrade Utilities
■ Compaq Diagnostics
CAUTION: Do not select the Erase Utility when running the SmartStart and Support
Software CD. This will result in data loss to the entire system.
Running Compaq Utilities
Compaq utilities may be accessed from the Compaq System partition on the hard drive, from
diskette, or from the Compaq SmartStart and Support Software CD.
Running the Utilities on the Compaq System Partition
If the system was installed using SmartStart, the Compaq utilities will automatically be
available on the Compaq system partition. The Compaq system partition could also have been
created during a manual system installation.
To run the utilities on the Compaq system partition, boot the system and press F10 when you
see: “Press F10 for Compaq system partition utilities.” Then select the utilities from the menu.
■ The System Configuration Utility is available under the System Configuration menu.
■ The Array Configuration Utility is available under the System Configuration menu.
■ Compaq Diagnostics (Test and Inspect) are available under the Diagnostics and Utilities
menu.
■ The ROMPaq Firmware Upgrade Utility is available under the Diagnostics and Utilities
menu.