beautypg.com

Active blind spot detection, Active blind spot detec‐ tion* 98, Active blind spot detection, refer to – BMW 760Li Sedan 2010 User Manual

Page 98: Last setting, on/off, Safety

background image

Sensor view field

The view field of the sensor is located on the
front of the interior rearview mirror.
Do not cover this area with stickers, etc.

Clean the view field, refer to page 252

.

Active Blind Spot Detection*

The concept

Two radar sensors below the rear bumper mon‐
itor the area behind and next to the vehicle at
speeds above approx. 30 mph/50 km/h.
The system indicates whether there are vehicles
in the blind spot, arrow 1, or approaching from
behind on the adjacent lane, arrow 2.
The lamp in the exterior mirror housing lights up
dimly.

Before you change lanes after setting the turn
signal, the system issues a warning in the situa‐
tions described above.
The lamp in the housing of the exterior mirror
flashes and the steering wheel vibrates.

Switching on/off

Press the button.

On: the LED lights up.

Off: the LED goes out.

The system can issue warnings at speeds above
approx. 30 mph/50 km/h.
The state is stored for the remote control cur‐
rently in use.

Display

Information stage

The dimmed lamp in the mirror housing indi‐
cates when there are vehicles in the blind spot
or approaching from behind.

Warning

If the turn signal is set while a vehicle is in the
critical zone, the steering wheel vibrates briefly
and the lamp in the mirror housing flashes
brightly.
The warning stops when the turn signal is
switched off or the other vehicle leaves the crit‐
ical zone.

Seite 98

98

Online Edition for Part no. 01 41 2 602 638 - © 09 09 510 BMW AG

Safety

This manual is related to the following products: