Auto hold 67, Deactivate, Activating – BMW 760Li Sedan 2010 User Manual

Page 67: Automatic hold, re

Place the release tool on the release point,
arrow.

Forcefully pull the release tool up against the
resistance until you notice a marked in‐
crease in the resistance and the parking
brake releases audibly.

Have the malfunction corrected
If the parking brake has been released

manually in response to a malfunction, only
technicians can return it to operation.
Have the malfunction corrected by your author‐
ized dealership.◀

After a power failure

Only put the parking brake into operation
after a power failure

The parking brake should only be put into oper‐
ation again if it was manually released due to an
interruption in the supply of electrical power.
Otherwise, it cannot be ensured that the parking
brake will function properly.◀

Putting the parking brake into

operation

Switch on the ignition.

Press the switch while the brake is de‐

pressed or transmission position P is en‐
gaged.

It may take several seconds for the brake to be
put into operation. Any sounds associated with
this are normal.

The indicator lamp in the instrument
cluster goes out as soon as the parking
brake is ready for operation.

Indicator lamp in Canadian models

Automatic Hold

The concept

This system assists the driver by automatically
setting and releasing the parking brake, such as
when moving in stop-and-go traffic.
The vehicle is automatically held in place when
it is stationary.
On inclines, the system prevents the vehicle
from rolling backward when driving away.

For your safety

Automatic Hold is deactivated automatically and
the parking brake is set when:

▷

The engine is switched off.

▷

A door is opened and the driver's safety belt
is unbuckled.

▷

The vehicle is braked to a standstill with the
parking brake while driving.

Seite 67

Reference

Mobility

Communication