beautypg.com

Ftm flat tire monitor – BMW 760Li Sedan 2010 User Manual

Page 95

background image

telltale illuminates, you should stop and check
your tires as soon as possible, and inflate them
to the proper pressure. Driving on a significantly
under-inflated tire causes the tire to overheat
and can lead to tire failure. Under-inflation also
reduces fuel efficiency and tire tread life, and
may affect the vehicle's handling and stopping
ability. Please note that the TPMS is not a sub‐
stitute for proper tire maintenance, and it is the
driver's responsibility to maintain correct tire
pressure, even if under-inflation has not reached
the level to trigger illumination of the TPMS low
tire pressure telltale. Your vehicle has also been
equipped with a TPMS malfunction indicator to
indicate when the system is not operating prop‐
erly. The TPMS malfunction indicator is com‐
bined with the low tire pressure telltale. When
the system detects a malfunction, the telltale will
flash for approximately one minute and then re‐
main continuously illuminated. This sequence
will continue upon subsequent vehicle start-ups
as long as the malfunction exists. When the mal‐
function indicator is illuminated, the system may
not be able to detect or signal low tire pressure
as intended. TPMS malfunctions may occur for
a variety of reasons, including the installation of
replacement or alternate tires or wheels on the
vehicle that prevent the TPMS from functioning
properly. Always check the TPMS malfunction
telltale after replacing one or more tires or
wheels on your vehicle to ensure that the re‐
placement or alternate tires and wheels allow
the TPMS to continue to function properly.

FTM Flat Tire Monitor*

The concept

The system detects a pressure loss on the basis
of speed differences between the individual
wheels while driving.
In the event of a pressure loss, the diameter and
therefore the rotational speed of the corre‐
sponding wheel changes. This is detected and
reported as a flat tire.

Functional requirements

The system must have been initialized when the
tire inflation pressure was correct; otherwise,
reliable signaling of a flat tire is not ensured. In‐
itialize the system after each correction of the
tire inflation pressure and after every tire or
wheel change.

System limits

Sudden tire damage
Sudden serious tire damage caused by

external influences cannot be indicated in ad‐
vance.◀
A natural, even pressure loss in all four tires can‐
not be detected.
The system could be delayed or malfunction in
the following situations:

When the system has not been initialized.

When driving on a snowy or slippery road
surface.

Sporty driving style: slip in the drive wheels,
high lateral acceleration.

When driving with snow chains*.

Initialization

The initialization process adopts the set inflation
tire pressures as reference values for the detec‐
tion of a flat tire. Initialization is started by con‐
firming the inflation pressures.
Do not initialize the system when driving with
snow chains*.

1.

"Vehicle Info"

2.

"Vehicle status"

3.

"Reset"

Seite 95

95

Online Edition for Part no. 01 41 2 602 638 - © 09 09 510 BMW AG

Reference

Mobility

Communication

Entertainment

Navigation

Driving tips

Controls

At a glance

This manual is related to the following products: