Edge Lighting Soft Line indirect LED lighting system, featuring Soft Strip User Manual
Soft line standoff, Install the outrigger, Installation instructions for

Installation Instructions for
Soft Line Standoff
Install the Outrigger
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
- This product allows Soft Line to run from wall to wall, wall
to ceiling, & ceiling to ceiling.
IMPORTANT INFORMATION
1
aircraft cable post will be located.
: Determine the location of where the standoff post and the
904-SL ACC-02
NOTE:
This installation instruction should be used concurrently
with Soft Line turnbuckles.
NOTE:
The rigged standoff should be installed within 10" from
the turnbuckle. The aircraft cable post should be installed inline
between the turnbuckle & ridged standoff to avoid the standoff
sagging. It is recommended to install additional standoffs in the
middle for the runs longer than 15ft.
A
CEILING
TURNBUCKLE
WITHIN 12"
to 24"
TURNBUCKLE
RIGGED STANDOFF MUST BE AT LEAST
10" AWAY FROM THE TURNBUCKLE
WALL
ELECTRICAL BOX
SOFT LINE
1
1
RIGGED
STANDOFF
AIRCRAFT
CABLE POST
TOP VIEW
B
2: O
rom the end of the rigged
rod, mark the
point where the
to be shortened
(minimum 12").
3: Cut at the marked point with a hacksaw.
4: Clean the inside and the outside burrs where cut.
ptional: f
standoff
standoff rod needs
RIGGED STANDOFF ROD
2
3
STANDOFF
POST