Edge Lighting Twiggy, Tubular 1" Lens - Manual (Page 4)

4
M
LOCKING CLIP
WALL
6
6: Connect each power supply wire to a fixture body wire with
a wire nut.
7: Place the wires and wire nut connection inside the junction
box.
JUNCTION BOX
WHITE (NEUTRAL)
GENERAL WIRING DIAGRAM
ELECTRONIC LOW
VOLTAGE DIMMER
INPUT
120VAC
BLACK (HOT)
AUDREY CHANNEL
LED TRANSFORMER
WHITE (NEUTRAL)
BLACK (HOT)
RED (12VAC)
RED (12VAC)
YELLOW
FIXTURE
BODY
N WALL
8
FIXTURE
BODY
LOCKING CLIP
JUNCTION BOX
RECEIVING BRACKET
BACK VIEW
8
LOCKING CLIP
8
MOUNTING CLIP
8: Carefully snap fixture body onto the locking & mounting
clip(s) then slide into receiving bracket to lock in place.
Make sure not to nick the wires.
NOTE: If the receiving bracket interferes with the electrical box,
then relocate the bracket by loosening the set screws and make
the necessary adjustments.
13 (OPTIONAL): For 4" Square Canopy installations, place
each canopy piece against the crossbar and secure it to the
electrical box holes with the provided #4-40 screws using the
1/16 Allen wrench.
13
13
FIXTURE BODY
CANOPY
#4-40
SCREW
1/16
ALLEN
WRENCH
O
WALL