Edge Lighting Twiggy, Tubular 1" Lens - Manual

904-TW12-T1-01
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
- This product is wall mount only.
- This product is dimmable with a low-voltage electronic
dimmer.
- This product must be installed by a qualified electrician.
- The 1RE version mounts to the provided C-1RE-JBOX. The
4SQ version mounts to standard electrical
box with plaster ring or octagon box.
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2013 Edge Lighting. All Rights Reserved.
1
2 3
1
2 3
1
A
JUNCTION
BOX
MOUNTING
BRACKET
1: Determine channel orientation. Mount each adjustable
mounting bar to one side of the junction box and secure
them with the provided mounting brackets and two Phillips
screws.
ADJUSTABLE
MOUNTING BAR
PHILLIPS
SCREW
1
VERTICAL
ORIENTATION
HORIZONTAL
ORIENTATION
1
JUNCTION
BOX
2
3
1
2
3
1
Section One: Steps For TW12-1RE Version
J-BOX IN
MIDDLE
J-BOX
OFFSET
w/4" SQUARE CANOPY
5: Remove a knockout to install the power line conduit.
6: Install the conduit and run the 120V power wires.
JUNCTION
BOX
STUD 5
6
2
3
1
2
3
1
CONDUIT
1RE
2
3
1
2
3
1
2:
box to be mounted.
3: Place the adjustable mounting bars between the studs.
4: Make sure the lips on the adjustable mounting bars are
against the studs. Secure the adjustable bars to the studs
with the eight #8 screws.
Select the location between the two studs for the junction
NOTE: The adjustable mounting bars mount to studs that are spaced
13" to 24" apart.
B
JUNCTION
BOX
ADJUSTABLE
MOUNTING BAR
STUD
#8 SCREW
3
4
2
FIXTURE LOCATION
CENTER LINE
NOTE: Ensure the opening of the junction box is alinged with the
center of the desired fixture location. If necessary, adjust the junction
box location by loosening the screws and sliding the junction box to
the proper location. Tighten the Phillips screws after adjusting.
C
Installation Instructions for Twiggy Tubular Lens 12 VAC
TW12-T1-1RE-_
TW12-T1-4SQ-_