Edge Lighting Vega Round - Manual (Page 2)

2
5: While holding the aircraft cables slide the mounting plate,
cover and the socket assembly down until the desired height
is achieved.
6: Tighten the set screw on each strain relief bushing with the
1.5mm Allen wrench.
7: Slide the strain relief down the aircraft cable against the
mounting plate and tighten the Phillips screw. Repeat this
step for the remaining strain reliefs.
C
AIRCRAFT
CABLE
7
NUT
5
7
D
8: Cut the excess aircraft cables off with a sharp cutter (Leave
at least 3" of the cable behind the strain reliefs).
9: Pull the excess clear cord out of the mounting plate and
tighten the cord grip.
AIRCRAFT
CABLE
3"
8
8
9
CLEAR CORD
MOUNTING PLATE
10: From the end of the clear cord, strip the outer insulation
using a sharp knife. Make sure not to nick the inner
wires and trim off the cutout insulation.
E
9
CORD GRIP
10
1.5MM ALLEN
WRENCH
6
5
F
11
11: Replace the wires with the black and white tags near the
insulation. Leave 6" of the wire behind the mounting plate
for power connection. Trim off the excess wires.
6"
MOUNTING PLATE
STRAIN RELIEF
BUSHING
COVER PLATE