Edge Lighting Vega Round User Manual
Vega round and oval (halogen version), Adjust the fixture height, Installation instructions for

Installation Instructions for
Vega Round and Oval (Halogen Version)
904-VEGA-H1-02
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor locations.
- This product can ONLY be ceiling mounted.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a low voltage electronic
dimmer.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
Adjust the Fixture Height
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
VEGA-H1-_
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
GLASS SHADE
A
H
MOUNTING
PLATE
1: Determine the desired fixture height (H), from the bottom of
the glass shade to the top the mounting plate.
1
B
AIRCRAFT
CABLE
STRAIN
RELIEF
2
2
STRAIN
RELIEF
AIRCRAFT
CABLE
MOUNTING PLATE
4
2
CORD GRIP
CLEAR CORD
2: Loosen the Phillips screw on each of the strain reliefs (Do
Not Remove).
3: Loosen the set screws on the strain relief bushings with the
the provided 1.5mm Allen wrench.
4: Loosen the cord grip to adjust the clear cord.
1.5MM ALLEN
WRENCH
3
STRAIN RELIEF
BUSHING
© 2009 Edge Lighting. All Rights Reserved.