Edge Lighting Graciano - Manual (Page 2)

5: Loop the end of the aircraft cable into the other strain relief
hole and tighten the two M4 set screws with the 2mm Allen
wrench.
6: Trim off excess aircraft cable behind the strain reliefs with a
sharp cutter.
7: Loosen the slotted set screw on the cord grip with a flat
screwdriver and push the excess clear cord into the canopy.
8: Tighten the slotted set screw on the cord grip to lock the
clear cord in place.
D
8"
C
CLEAR CORD
SOCKET HOUSING
CANOPY
AIRCRAFT CABLE
9: Leave 8" of the clear cord exposed behind the canopy for
power connection. Trim off the excess clear cord.
10: From the end of the clear cord, strip 4" of the outer
insulation using a sharp knife. Make sure not to nick the
inner wires. Trim off the cut out insulation.
E
11: Mount the crossbar assembly to the electrical box holes
with the two #8-32 screws provided.
11
CROSSBAR ASSEMBLY
#8-32 SCREW
F
12: Make sure the power to the electrical box is off.
13: Make sure that the canopy is grounded in accordance with
local electrical codes.
14: Connect the clear wire with a rough edge to the neutral
power wire with a wire nut.
15: Connect the other clear wire to the hot power wire with a
wire nut.
WARNING! RISK OF FIRE! : Aircraft cable is to support the
fixture and should not come in contact with ground or power
wires.
NOTE: It is recommended a person to hold the fixture while the
electrician connects the power to the fixture.
10
2
5
7
8
9
15 14
6