Edge Lighting Crystal Veil - Manual (Page 4)

4
N
13
14
15
13:
accordance with local electrical codes.
14: Connect the smooth edge wire of the cord to the hot power
wire with a wire nut.
15: Connect the rough edge wire of the cord to the neutral
power wire with a wire nut.
Make sure that the crossbar assembly is grounded in
O
16:
box.
17: Slide the canopy up against the electrical box. Tighten the
knurled nut to the hook bushing threads. If necessary
loosen the hook bushing a little bit so that the knurled nut
can reach the hook bushing threads.
Place all wires and wire nut connections inside electrical
ELECTRICAL
BOX
CANOPY
KNURLED NUT
16
17
P
SOCKET
LAMP
1
1 1
1
Install the Lamp & Shade
1: Screw each lamp completely into one socket.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 60 Watt Type E12 base, Torpedo Style
Candelabra Base Lamp For Each Socket.
Q
SUPPORT ARM
SHADE TAB
2
2: Slide the fabric shade from the bottom of the chandelier up.
Align and set the shade tab holes onto the support arm ends.