Edge Lighting Crystal Veil - Manual

SAVE THESE INSTRUCTIONS!
- This product is UL listed for indoor dry locations.
- This product is ceiling mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
Installation Instructions for Crystal Union & Crystal Veil Chandeliers
904-CRYSTAL-UV-01
IMPORTANT INFORMATION
Install the Crystals
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
CRYSTALU-S-IV
CRYSTALVE-S-WH
© 2010 Edge Lighting. All Rights Reserved.
A
A:6pcs
B:6pcs
E:6pcs
C:6pcs D:6pcs
A1:1pc
1: To install a crystal, squeeze the key ring to open the end.
Slide the end through the designated hoop and rotate it
inside the hoop to lock in place.
NOTE: It is recommended to hang the crystals before installing
the chandelier. Follow step 1 to install all crystals. Follow steps 2
through 7 to install the crystals in correct position and orientation.
1
B
2: Install the single crystal marked "A1" into the hoop located
in the center of the bottom glass.
3: Install the six pieces of crystals marked "E" into the hoops
located around the perimeter of the bottom glass.
CRYSTAL NAME:QUANTITY
KEY RING
HOOP
"A1" CRYSTAL
"E" CRYSTAL
BOTTOM
GLASS
3
1
CRYSTAL
C
4: Install the six pieces of crystal marked “D” into the hoops
located on the bottom of each curved socket stem, so that
one end is hooked into one socket stem hoop and the other
end into the adjacent socket stem hoop. Each curved socket
stem will hold two crystal key rings when all crystals are
installed.
"D" CRYSTAL
4 CURVED STEM
2
®