Edge Lighting Crystal Galaxy with Downlight - Manual (Page 3)

3
9: Feed the extension wires through the transformer housing
center hole. Slide the transformer housing onto the
crossbar assembly nipple and secure it in place by
tightening the washer and inside nut.
CROSSBAR ASSEMBLY
NIPPLE
F
ELECTRICAL
BOX
WASHER
INSIDE NUT
EXTENSION WIRES
HOUSING
9
10: Connect the white transformer wire to the neutral power
wire with a wire nut.
11: Connect the black transformer wire to the hot power wire
with a wire nut.
G
10
11
12: Press the tab on the end of the center mounting standoff in
to feed the fixture suspension cable through. Adjust the
fixture height to desired position. Trim excess suspension
cable close to center mounting standoff.
H
NOTE: It is recommended that more than one person assist in
installing this fixture to avoid damage or injury.
I
13: Feed one fixture power cable through each grommet
opening in the power supply canopy.
14: Trim power cables after WARNING! RISK OF FIRE:
adjusting fixture height. Leave only enough power cable
inside the canopy to complete electrical connections. DO
NOT coil excess power cable inside canopy!
12
SUSPENSION CABLE
12 TAB
CENTER
MOUNTING STANDOFF
POWER CABLE POWER CABLE
Trim excess
cable.
DO NOT
COIL!
Trim excess
cable.
DO NOT
COIL!
13 13