Edge Lighting Cirrus Float End Feed - Manual (Page 3)

18: Use the provided 1.5mm Allen wrench to replace and
securely tighten the M3 set screw.
19: Use the provided 2mm Allen wrench to securely tighten the
M4 set screw until it squeezes the wire ferrule tightly to the
coaxial cable.
20: Replace the coaxial connector cover and tighten into
place.
1.5MM ALLEN
WRENCH
18
CONNECTOR
ASSEMBLY
COAXIAL
CABLE
2MM ALLEN
WRENCH
19
CONNECTOR
ASSEMBLY
COAXIAL
CABLE
M3 SET
SCREW
M4 SET
SCREW
20
COAXIAL CONNECTOR
COVER
COAXIAL
CABLE
K
L
M
21
N
3
21: Connect the white transformer wire to the neutral power
wire with a wire nut.
22: Connect the black transformer wire to the hot power wire
with a wire nut.
23: Place the transformer and transformer wires inside the
junction box.
22
25
24
24: Connect one red transformer wire (either one) to the black
coaxial connector wire using a wire nut
25: Connect the other red transformer wire to the red coaxial
connector wire using a wire nut.
26: Place all connections into the junction box.
27: Secure the power canopy to the junction box using two #8-
32 screws.
POWER
CANOPY
CANOPY POST
#8-32
SCREWS
27
O
P
NOTE: Ensure that power to the junction box is OFF before
beginning any electrical work.