Edge Lighting Cirrus Float End Feed - Manual

SAVE THESE INSTRUCTIONS!
- This product is suitable for indoor locations.
- This instruction shows a typical installation.
- Ensure that power to the junction box is OFF before
beginning any electrical work.
IMPORTANT INFORMATION
Installation Instructions for Cirrus Float End Feed
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2014 Edge Lighting. All Rights Reserved.
1
904-CF-D1-E-02
CF-D1-E-_
Install the Fixture
1: Measure the distance between the coaxial cable and the
aircraft cable mounted on the channel. This measurement
varies on the fixture length.
2: Mark the standoff location from the center of the electrical
box for the distant achieved on step 1.
A
H
CHANNEL
CANOPY STANDOFF
ANCHOR
ANCHOR MUST
BE FLUSH TO CEILING
B
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
CEILING
3
4
L
STANDOFF
CANOPY
TOP VIEW
#8 SCREW
WASHER
W/THREADED
NIPPLE
5
STANDOFF
POST
C
WASHER
W/THREADED
NIPPLE
6
5: Feed the #8 screw through the washer w/threaded
nipple into the anchor.
6: Tighten the #8-32 screw completely into the anchor.
7: Tighten the standoff posts completely onto the threaded
nipple.
7
COAXIAL CABLE
AIRCRAFT CABLE
8: Push the tab on standoff and feed the aircraft cable from
the channel into a standoff, to hold the one end of the fixture
in place.
D
STANDOFF
POST TAB
AIRCRAFT
CABLE
8
8