Dynalco SC-2124M Scanner/Monitor - Manual (Page 7)

7
2.0 Installation
Installation requires a cutout as shown in section 2.1 along with four mounting holes. Once
the unit is mounted, a nearby (less than 6 feet away) location is needed for performing the
wiring to separate terminals. One method is to purchase the optional DB-to-Screw-Terminal
modules which are DIN-RAIL mounted. Also, the supplied Cold Junction Compensation
(CJC) Sensor is necessary if any thermocouples are to be used. The Dynalco ETS-202 CJC
sensor should be mounted as close as possible to the location where the thermocouple wires
are terminated.
2.1 Panel Cutout
7.
5
0
6.
2
5
7.
8
5
5.
3
0
.1
8
7
5
PANEL
CUTOUT