Dynalco SC-2124M Scanner/Monitor - Manual (Page 33)

33
Appendix C
Channel 7 Input Settings
P a r a m e t e r F u n c t i o n D e s c r i p t i o n V a l i d I n p u t s
110.7= Channel name for CH07 Default=” “ (blank=CH07)
11 characters (including spaces)
111.7= Units of measure for CH07
0= deg F (default)
1= deg C
2= PSI
3= PSA
4= KPA
5= FTP
6= RPM
7= “ “ (blank)
8001.7= Input type for CH07 0= J-TC (default)
1= K-TC
2= Nickel RTD
3= Platinum RTD
4= 4-20 mA (DIP 7 switch on))
5= 0-5 V
8000.7= Enables CH07 for scanning 0= disabled (default)
1= enabled
8017.7= Filter speed for CH07 Minimum=0.00 (none)
Default=0.05 (slow)
Maximum=1.00 (fast)
8012.7= Display value for 0 V or 4 mA input Minimum=-999.0
8013.7= Display value for 5 V or 20 mA input Default= 0.0
Maximum=9999.0
(in channel units)
8015.7= Inverted resistance for 4-20mA source on CH07 Minimum=0.0 1/kohms
Default=10.0 1/kohms
Maximum=100.0 1 /kohms
8008.7= CH07 output offset to add to computed output value
Minimum=-1000.0
Default= 0.0
Maximum= 1000.0
(in channel units)
63000.7= Shutdown trip class for CH07
0= Off
1= Class A over (default)
2= Class B over
3= Class C over
4= Class A under
5= Class B under
6= Class C under
63001.7= Shutdown threshold value for CH07 Numeric value
63002.7= Shutdown threshold hystersis for CH07 (channel units)
63003.7=
Delay time between exceeded CH07 shutdown threshold and
CH07 shutdown
seconds
63000.31= Alarm trip class for CH07
0= Off
1= Class A over (default)
2= Class B over
3= Class C over
4= Class A under
5= Class B under
6= Class C under
63001.31= Alarm threshold value for CH07 Numeric value
63002.31= Alarm threshold hysteresis for CH07 (channel units)
63003.31= Delay time between exceeded CH07 alarm threshold and
CH07 alarm seconds