Cooper Instruments & Systems DFI Infinity CS Economy Digital Indicator - Manual (Page 23)

DFI INFINITY CS (V- M3598/N/0906) 20 CF 70
1. Press the MENU button until the meter shows .
2. Press the
X/TARE button. The meter shows the last previously stored 4-digit number (0000 through 9999)
with flashing 4
th
digit.
3. Press the
S/NT/GRS button to change the value of the flashing digit. If you continue to press the S/NT/GRS
button, the flashing digit’s value continues to change.
4. Press the X/TARE button to scroll to the next digit.
5. Press the MENU button to store the selection. The meter momentarily shows , followed by
(Setpoint 2 Deadband).
4.9 Setting the Setpoint 2 Deadband
Refer to Table 6-1 for a summary list of menu configuration.
Setpoint 2 Deadband is not active unless your meter has dual relay output capabilities. The LED’s will
display whether the is active or not. The Setpoint 2 default deadband is 0003. To change the deadband
(hysteresis) of Setpoint 2, follow these steps:
1. Press
the MENU button until the meter shows .
2. Press the
X/TARE button. The meter shows the last previously stored 4-digit number (0000 through 9999)
with flashing 4 th digit.
3. Press the S/NT/GRS button to change the value of the flashing digit. If you continue to press the S/NT/GRS
button, the flashing digit’s value continues to change.
4. Press the X/TARE button to scroll to the next digit.
5. Press the MENU button to store your selection. The meter momentarily shows , followed by
(Output Configuration) if you have analog output capabilities.
Figure 4-1 Alarm Example