Running signal accumulation mode (sam) protocols – Bio-Rad Image Lab™ Software User Manual
Page 92
4 | Acquiring Images
92 | ChemiDoc MP Imaging System with Image Lab Software
Running Signal Accumulation Mode (SAM) Protocols
You can interrupt the acquisition of images for a SAM-enabled protocol at any time
by clicking Stop Acquire and Continue with Selected. The acquisition process stops
and continues the protocol with the selected image. Any other images that were
acquired are discarded.
At the end of the acquisition process, a thumbnail of each image appears at the
bottom of the window. The last image acquired appears, by default, in the main
window. You can view any of the SAM images in the main window by clicking on the
thumbnail image.
Review the images, select the image you want to use in your analysis, and click
Select Image and Continue. Image Lab continues to the next step in the protocol
using the selected image.
Note: After you click Select Image and Continue, only the selected image is
retained. All other images are deleted. Therefore, save any images you want to
keep before continuing with the protocol. See
for more information.