B&G H2000 Pilot *DISCONTINUED* - Manual (Page 85)

HB-0844-04
3-20
SYS Receiving data from a B&G system compass or NMEA
input to NMEA FFD or performance processor
PASS Calibration swing is complete
FAIL Calibration swing failed and the compass needs to be re-
calibrated.
xxxº Number of degrees turned during calibration swing
3.4.7 Halcyon Processor NMEA output setup
NMEA sentence output settings determine what sentences are output with
respect to which heading source is available.
MISC
→ →HALCYON, CALIBRATE→ →CAL VAL 2 (NMEA MDE)
0 HDT from Halcyon Gyro Stabilised Compass or NMEA input to
Halcyon Gyro Processor
1 HDM from Halcyon Gyro Stabilised Compass or NMEA input to
Halcyon Gyro Processor
2 HDG from Halcyon Gyro Stabilised Compass or NMEA input to
Halcyon Gyro Processor
3 HDM/HDT from a B&G system [compass or NMEA input], or
NMEA input to Halcyon Gyro Processor
4 HDG from a B&G system [compass or NMEA Input], or NMEA
input to Halcyon Gyro Processor
NOTE:
Mode 0 is the default value
Mode 3 will output the correct sentence depending on configuration.
Navigate
→ →Heading, CALIBRATE→ →CAL VAL 2.
0 Magnetic
1 Auto (will set to True if Mag var is available, otherwise
will stay in Magnetic)
If Mode 4 is selected and magnetic variation is not available then the
magnetic heading will be output.