B&G H2000 Pilot *DISCONTINUED* - Manual (Page 136)

HB-0844-04
5-19
5.9.4 Off Course Function
The Off Course function provides the helmsman with accurate Off Course
information to assist in steering a steady and accurate course.
Off Course is calculated by comparing the yacht’s current heading with a
previously set reference heading. The deviation is shown by the bar graph
and numerically as degrees port or starboard.
The bar graph scale shows one segment for every 2
°
off course up to 10
°
,
then one segment for every 5
°
up 20
°
. If the current heading is the same as
the desired heading then only the central segment will be shown. The
numeric display will show 00.
The Off Course function may be reset by pressing the Enter Key, operation
of a Remote Push-button if fitted or from any FFD. Pressing the Enter Key
or Remote Push-button will select the current heading as the reference
heading.
Any deviation from this new course will be shown on the bar graph and the
numerical display.
To reset the off course function from an FFD, select the NAVIGATE Menu
and then OFF CRSE as described in Part 2 - Operating Information.
5.9.5
Stored Course Function
Up to 10 preset courses, numbered CRS 1 to CRS 10, may be stored at any
one time. When the Stored Course function is selected by operation of the
Page Key the display changes to show the selected course number with the
value immediately below. All courses are retained in the Halcyon Display
memory during power off so that the desired courses may be entered prior
to departure.
To select a specific course number proceed as follows:
(1) Select the Stored Course Function by successive presses of
the Page Key until the display shows the Stored Course Function.
(2) Press Scroll Up and CRS 1 will flash.
(3) Using the Scroll Up and/or Scroll Down Keys select the
course (CRS) number required.